Archive

This in vitro materials study compares microwave irradiation versus conventional water-bath heating for synthesizing HPMC-graft-(PVA-co-acrylic acid) hydrogels loaded with captopril. The authors report that microwave-synthesized hydrogels had more uniformly porous structures and higher swelling ratios, with…

This laboratory study investigated ring-opening polymerization of ε-caprolactone using organic-acid catalysts to produce poly-ε-caprolactone intended as a biodegradable drug carrier. The authors report that citric acid catalysis yielded substantially higher molecular weight polymer than other catalysts. They also…

This in vitro study evaluated microwave disinfection of dental stone casts contaminated with Bacillus subtilis under wet and dry conditions. After a drying step for the dry group (450 W for 15 minutes), both wet and dry casts were exposed to 900 W for 5 minutes and cultured to quantify CFU/mL. The authors report…

This laboratory study examined how UV-C radiation, an electromagnetic field, microwave radiation, and ultrasound affected polyphenolic compounds in chokeberry. Using UPLC-PDA-MS/MS, the authors report that UV-C, microwaves, and ultrasound generally increased several polyphenolic groups, while the electromagnetic…

This in vitro study compared microwave irradiation with chemical (2% glutaraldehyde, Corega tablets) and mechanical (brushing) methods for disinfecting complete dentures contaminated with two microorganisms. Microwave irradiation (650 W for 3 minutes) and both chemical methods showed no detectable bacterial growth at…

This in vitro study tested 900-W microwave radiation regimens (3, 5, or 7 minutes) to disinfect type IV dental stone surfaces contaminated with S. aureus, E. coli, or C. albicans. The authors report that 5 and 7 minutes achieved sterilization for S. aureus, while 3 minutes did not fully sterilize; all times were…

This paper describes an engineering approach to avoid RF/microwave radiation in wearable EEG data transmission by using visible light communication. The system performance was tested at different illuminance levels and an algorithm for low-illuminance operation was proposed. The authors report error-free transmission…

This engineering study describes using antenna-coupled microwave radiation to enhance laser-induced breakdown spectroscopy (LIBS) emission from a Gd2O3 sample at reduced pressure. The authors report substantially increased plasma emission intensity, higher-temperature plasma, and longer emission lifetime when…

This animal study tested whether pre-exposure to microwave radiation from a GSM mobile phone simulator could induce a radioadaptive response to a subsequent lethal whole-body gamma dose. In mice, pre-exposure to microwave radiation, low dose rate gamma radiation, or both was associated with significantly different…

This engineering study describes a microwave-assisted method to synthesize polyaniline (PANI) nanofibers. Reported yields under microwave irradiation were similar to conventional synthesis but achieved in minutes rather than hours. Structural and morphological characterization (FTIR, Raman, SEM, TEM) reportedly…

This engineering/materials study synthesized nanocrystalline hydroxyapatite bioceramic powder using microwave radiation and then characterized the resulting material. The authors report highly crystalline HAp nanopowder with nanoscale size, mixed morphology, and elemental composition consistent with the HAp phase.…

This engineering/materials study describes blending PLLA and PGA using microwave irradiation to produce PLGA-related blends with varying constituent concentrations. The authors report that FTIR, NMR, and DSC measurements indicate blending and cross-linking between the polymers. The abstract does not provide microwave…

This laboratory study tested microwave radiation (10 and 60 mW/cm2 for 5, 30, or 60 minutes) on fungal and actinomycetal spores grown on agar and on common building materials under wet and dry humidity conditions. Reported effects on spore viability depended on strain, growth conditions, humidity, power density, and…