Archive

This engineering study addresses stray magnetic fields as a performance-limiting imperfection for the Compact Linear Collider (CLIC), where simulations indicate sensitivity to fields on the order of 0.1 nT. It presents DC and AC magnetic characterization of two Mumetal® samples (annealed in final form vs…

This cross-sectional survey in five French cities assessed whether measured RF-EMF exposure from mobile-phone base stations was associated with self-reported non-specific and insomnia-like symptoms among residents living within 250 m of a base station. Overall, measured base-station exposure was not associated with…

This engineering/methods study addresses computational artifacts that can affect coupling factor calculations for localized EMF exposure assessment in IEC 62311/62233, particularly below 10 MHz. The authors propose using the 99.99th percentile rather than the maximum internal quantity to mitigate abnormal peaks from…

This paper describes multi-floor indoor LTE measurement campaigns aimed at enabling assessment and monitoring of RF-EMF exposure, with emphasis on uplink exposure via mobile phone transmit power. Because uplink transmit power is not directly available from off-the-shelf devices, the authors propose an artificial…

This paper presents a 3D GIS approach to model magnetic fields from overhead high-voltage power lines while accounting for terrain relief and cable catenary. The model was validated against extensive field measurements in two complex urban environments and showed good agreement with measured values, though accuracy…

This report discusses elements of new AIRM (Italian Association of Medical Radiation Protection) guidelines for health surveillance of workers exposed to electromagnetic fields. It focuses on identifying which workers should undergo surveillance and what surveillance should include. The approach described emphasizes…

This exposure assessment measured RF-EMF levels in 21 state hospitals in Samsun Province, Turkey using short-term, long-term, and band-selective approaches across 100 kHz–3 GHz (total) and 27 MHz–3 GHz (band-selective). The study reports that the ICTA 3 V/m limit was exceeded in at least some hospital measurements,…

This paper discusses how rising man-made EMF from modern wireless technologies motivates careful regulation to keep exposure below levels expected to cause harm. It argues current regulations may not strictly constrain EMF when multiple nearby devices transmit simultaneously. The authors propose a…

This engineering study designed and tested a compact wideband self-grounded bow-tie RF antenna module for a whole-body 7.0 T MRI system, aiming to enable 1H/19F MRI, MR thermometry, and broadband RF thermal intervention. The authors report validated B1 efficiency measurements and phantom-based heating experiments…

This experimental study evaluated electromagnetic field (EMF) treatment as a chemical-free approach to mitigate biofouling in reclaimed water distribution systems. The authors report that EMFs altered biofilm bacterial communities, reduced diversity, disrupted co-occurrence network structure, and inhibited biofilm…

This paper discusses the legal context for environmental EMF measurements and describes methods for estimating EMF intensity from multiple sources, particularly cellular base stations. It presents an engineering concept for mobile EMF monitoring and reports verification testing of the measurement setup. Field…

This study tested pulsed low-frequency electromagnetic fields (up to 10,000 Hz; max 21 mT) as a potential alternative sanitation approach for poultry drinking water systems. LF-EMF exposure was linked to variable changes in culturable bacterial counts, with direction depending on system type and some early…

This exposure-assessment study used on-body calibrated personal exposimeters to characterize spatial and temporal variability of personal RF-EMF exposure across microenvironments in five cities in Flanders, Belgium. Brussels showed the highest mean total exposure, while Antwerp had higher downlink exposure than…

This conference paper describes an engineering design for a low-magnitude high-frequency vibrator with multiple plungers, aiming to minimize electromagnetic fields during vibrational stimulation experiments. The authors analyze the device’s EMF using finite element methods in COMSOL. No direct biological or health…

This pilot study evaluated weekly and annual cumulative RF-EMF exposure attributed to mobile phone use using objective phone-based measurements of transmitted and received power densities. Ten participants provided two months of daily data across usage modes (cellular calls, cellular data, and Wi-Fi). The study…

This study used real-time measurements on a university campus to examine how the number of users relates to RF electric field strength from cellular systems and a Wi-Fi access point. The authors report empirical models that estimate E from user counts, with stated accuracies of 86% for cellular-related measurements…